Energy Savings.
Holland Heaters are very efficient direct fired units. Due to their clean
burning, all the heat can be sent directly into the greenhouse. There is
no need to use a chimney or exhaust stack. Because of this they are 99%
fuel efficient. The largest unit available has a capacity of 440,000 BTU.
Because there is minimal heat loss, less units will be needed to heat your
greenhouse.
The heater has an air throw of 150 ft, convection tubing should not be used.
In addition there is no need for a chimney or a support frame. The heater
can be hung directly from trusses. Installation is therefore quite simple.
With 220V, 1 phase power and a natural gas line with 5 lbs. pressure available
the heater can be placed anywhere in the greenhouse. Propane heaters need
between 7 and 35 PSI . CO2 enrichment is an added value for the Holland
Heater. Since all the heat stays in the greenhouse, the CO2 produced by
the unit will go directly to the crop, boosting and strengthening the growth
of the plants. The heater is equipped with a fresh
air intake unit. It will bring in air from outside the greenhouse to
the burners to avoid reburning the air inside the greenhouse. The heater
is also efficient in electrical power use. The largest unit is rated at
only 4 amps.
All models have intergraded connections for both a thermostat and a computer. |
Click here for the technical specifications
on the different heaters that are available
 |